Spin Master Motorized Toy Car Boeing Delta Air Rocket User Manual

TM  
Pump  
Handle  
Air Tubing  
(Non-flexible)  
Handle  
Lock  
ROCKETS  
TM  
Launcher  
Shaft  
Connectors  
Nose  
Cone  
Air Tubing  
Clamp  
Launcher  
Holder  
Launcher  
Leg  
Rocket Holder  
Rocket Shaft  
INSTRUCTIONS  
Pumping  
Station Base  
Launch  
Release Cable  
Contents  
Launch  
Release Handle  
1 Launcher/Accumulator  
1 Pumping Station  
2 Rockets  
LAUNCHER/  
ACCUMULATOR  
PUMPING STATION  
PREPARING FOR LAUNCH  
STEP 1  
STEP 2  
Launcher  
Shaft  
LAUNCHER/  
Remove the  
LAUNCHER/  
ACCUMULATOR  
from the  
LAUNCHER  
HOLDER.  
Fold the LAUNCHER  
LEGS down so that it  
can stand on the ground.  
ACCUMULATOR  
Launcher  
Legs  
IMPORTANT:  
The LAUNCHER LEGS  
must be level and placed  
on a flat surface or the  
ROCKET will not launch.  
Launcher  
Holder  
LAUNCHER  
STEP 3  
STEP 4  
Air Tubing  
(Non-flexible)  
Remove HANDLE  
LOCK from its  
Unlock AIR TUBING  
CLAMP so that the  
AIR TUBING  
(Non-flexible) can  
be removed.  
mounting area under  
Handle  
Lock  
the PUMP HANDLE.  
Air Tubing  
Clamp  
 
LAUNCHING INSTRUCTIONS continued  
STEP 4  
STEP 6  
STEP 5  
While holding the PUMPING STATION steady, slowly  
pull the LAUNCH RELEASE HANDLE from the  
PUMPING STATION and watch your BOEING DELTATM  
AIR ROCKET reach heights of up to 120 feet.  
With both feet on the  
PUMPING STATION  
BASE, use the PUMP  
HANDLE to pump  
15 times. Use only the  
pump that comes with  
your BOEING DELTATM  
AIR ROCKET.  
Ensure that people  
and animals are not  
within a four foot  
radius of the rocket.  
Launch  
Release Handle  
NOTE: For safety,  
this pump has a unique  
built-in pressure  
relief valve to release  
air or whistle if the  
LAUNCHER/  
ACCUMULATOR is full.  
STORING YOUR BOEING DELTA™ AIR ROCKET  
STEP 1  
STEP 2  
STEP 3  
Rocket  
Holder  
Store the  
Unscrew all the CONNECTORS on the  
AIR TUBING.  
Fold the AIR TUBING and store it  
vertically in the AIR TUBING  
CLAMP. Snap the clamp closed.  
ROCKETS in  
the ROCKET  
HOLDERS.  
Air  
Tubing  
Clamp  
STEP 4  
STEP 5  
Launcher  
Shaft  
Fold the LAUNCHER  
LEGS back up on the  
LAUNCHER/  
ACCUMULATOR and  
secure it to the PUMPING  
STATION by clipping the  
LAUNCHER SHAFT into  
the LAUNCHER HOLDER.  
Attach HANDLE  
LOCK to its  
mounting area  
under the PUMP  
HANDLE.  
Launcher  
Holder  
Handle  
Lock  
PUMPING STATION  
LAUNCHER  
IMPORTANT SAFETY INFORMATION  
Keep clear from face and eyes. Do not launch at people or animals. Use caution; make sure people  
around you know you are playing with AIR HOGSTM. Recommended for use in wide open areas. Do NOT  
fly near overhead wires, trees, buildings, or other obstructions. Point toy away from face when launching.  
Do NOT fly in rain, sleet, electrical storms, or other adverse weather conditions.  
ADULT SUPERVISION RECOMMENDED.  
 
TROUBLE SHOOTING GUIDE  
PROBLEM  
CAUSE  
SOLUTION  
ROCKET does not  
launch.  
1. No air in LAUNCHER/  
ACCUMULATOR.  
1. Use the PUMP HANDLE and pump 15 times before  
pulling the LAUNCH RELEASE HANDLE.  
2. LAUNCHER/ACCUMULATOR is  
not positioned on a level surface.  
2. Re-adjust the LAUNCHER LEGS and make sure  
that the LAUNCHER is sitting on a level surface. If  
the LAUNCHER is tilted more than 15° to any side,  
the rocket WILL NOT LAUNCH.  
3. AIR TUBING and/or CONNECTORS  
are not completely straight.  
3. Ensure that all CONNECTORS are securely  
fastened, and that the AIR TUBING is in a straight  
line with the PUMPING STATION before launching.  
4. CONNECTORS on AIR TUBING  
not properly assembled/tightened.  
4. Unscrew each CONNECTOR and repeat Step 6  
in the “Preparing to Launch” section. Remember  
to tighten any loose cable before screwing the  
CONNECTORS together.  
5. LAUNCHER SHAFT not locked in  
place for launch.  
5. Push the LAUNCHER SHAFT down until  
it CLICKS.  
6. LAUNCHER SHAFT is JAMMED.  
6. The LAUNCHER SHAFT may have become  
jammed if it was pushed TOO HARD when you  
tried to CLICK it into position for launch. To un-jam  
it, 1. ASK AN ADULT FOR HELP. 2. Raise up the  
3 LAUNCHER LEGS, 3. remove ROCKET from  
launcher shaft, 4. have the child pull on the  
LAUNCH RELEASE TRIGGER at the same time  
as the ADULT pulls up on the LAUNCHER SHAFT  
to un-jam it.  
WARRANTY (U.S.A.)  
Spin Master Ltd. warrants to the original consumer purchaser, that this product is thoroughly tested and  
inspected before shipment and is guaranteed to be free of factory defects in materials and workmanship for thirty  
(30) days (unless specified in alternate warranties) from the date of purchase.  
In the event of such a defect within the warranty period, Spin Master Ltd., at our sole option, will repair or  
replace the product or provide you with another product of equal value. Repair or replacement shipment is free of  
charge. Shipping replacement may take 2 to 6 weeks, depending on customer’s location.  
In the event of a defect covered under this warranty, please call the toll-free number listed below. Many  
problems can be solved in this manner. If necessary, you will be instructed to return the defective part or unit,  
packed securely, postage prepaid and insured by the customer, to the address below. Enclose your name, address,  
dated sales receipt, and a brief explanation of the defect. There may be an additional handling charge if you send  
the entire toy.  
The warranty is valid if and only if the product has been operated in accordance with the instructions. This  
warranty does not cover worn or defective batteries, damage resulting from neglect, unauthorized modification, acci-  
dent, misuse, abuse, any action or omission which constitutes a deviation from the instructions or from the use of  
accessories or parts not manufactured by Spin Master Ltd. If the product is returned without a dated sales receipt  
the product is excluded from coverage under this warranty.  
Spin Master Ltd.’s liability for defects in material and workmanship under this warranty shall be limited to repair  
or replacement, at our sole option, and in no event shall we be responsible for accidental, consequential. or  
contingent damages (except in those states that do not allow this exclusion or limitation) or refunds. This warranty is  
exclusive, and is made in lieu of any express or implied warranty. This warranty is valid only for products sold in the  
U.S.A. This warranty gives you specific legal rights and you may have other rights, which vary from state to state.  
Some states do not allow the exclusion of incidental or consequential damages, so the above exclusions or limita-  
tions may not apply to you.  
Spin Master Ltd. reserves the right to improve the design of any product without assuming any obligation to  
modify any product previously manufactured.  
If you need assistance, please contact our Customer Care Center (below) for help.  
SPIN MASTER LTD.  
Air Hogs TM is a trademark of Spin Master Ltd.  
CUSTOMER CARE CENTRE  
450 Front Street West  
© 2003 Spin Master Ltd. All rights reserved.  
Produced under license from Boeing Management Company.  
Delta and Boeing are among the trademarks owned by Boeing.  
Manufactured for and distributed by Spin Master Ltd.  
Toronto, Ontario M5V 1B6 CANADA  
TOLL-FREE NUMBER 1-800-622-8339  
(valid only in North America)  
Hours: 8:00 A.M. – 5:00 P.M.  
Eastern Time: Monday – Friday.  
TM  
MADE IN CHINA  
Item #45044 REV 4 U.S. English  
 

Sharp Projector XV Z90U User Manual
Shure Microphone Beta 98H C User Manual
Sony Laptop PCG C1XS User Manual
Sony Personal Computer SVL24147CXB User Manual
Sony Universal Remote RM VL1000T User Manual
Spalding Fitness Equipment 21166904 User Manual
StarTechcom Switch SV1631D User Manual
Tanita Scale HD 338 User Manual
Targus Laptop ACP50 User Manual
Targus Laptop NOTEBOOK DOCKING station with video User Manual